Browse

In every technology as well as in Horizontal Directional Drilling (HDD), there are design challenges. Compliance with the requirements forces the application of modern solutions in the mentioned technology. One such solution is the Intersect Drilling method. The Intersect Drilling technology makes it possible to create a hole for Horizontal Directional Drilling of shallow layers and a longer length compared to conventional methods. The decision on whether the Horizontal Directional Drilling (HDD) project should be...

Multi-well pad drilling originates from offshore drilling where the use of this method is dictated by the limited mobility of platforms. Onshore group location of the wellhead slots is used since recently. It was first used in the Rocky Mountains in the USA in 2004. Beginning is related to the commencement of hydrocarbon extraction from unconventional reservoirs in the United States. Exploitation of unconventional shale and tight reservoirs with vertical wells is economically unprofitable because it is not possibl...

The Intersect Drilling method is a modern drilling technique for HDD (Horizontal Directional Drilling), giving a completely new dimension to Horizontal Directional Drilling technology. Its creation was mainly due to the need for drilling in difficult conditions, where drilling with the use of only one drilling device is often impossible or ineffective and could end in the failure of the entire project. To cope this it is necessary to apply modern solutions in this technology. One such solution is the Intersect Dri...

The aim of the project is to determine the optimum geometry and different kinds of nozzles location on the drilling tools face. The optimum geometry and its proper arrangement will allow the maximum use of specific mechanical energy drilling through its reduction and minimizing pressure losses to overcome flow resistance in the nozzles of a drill bit. In their previous work, the authors showed that hydraulic power is a very important aspect, affecting the loss of pressure at the bottom of a borehole. It has been s...

The right selections of BHA, (bottom hole assembly), provides to minimize cost of drilling through the elimination of fishing works, which could took place during drilling. In many cases during drilling operations there is need to maintain the continuity of pure drilling works in the wellbore through fishing works. The name of the time for these works, it is known as NPT ? nonproductive time. Before drilling the borehole, the engineers must took into account all geological properties and affordable technological s...